- Remote the top layer of the polystyrene from the carton.
- Ensure the screen is facing down, then take out the vertical rod, connect it with the quick disassembly position of the display screen, and then put the chassis on the other side of the Poly
dragon, pass the power cord at the bottom of the lower rod through the round
hole of the chassis, and connect it with the power cord of the chassis. - Once you are ready to connect the power to the screen, plug the cable coming out of the rod into the USB C port as seen in the images below.
The image above shows the location of the USB C Power port.
This image shows the USB C cable connected to the Power port on the back of the screen. - After connecting everything, plug the power into the base and allow the battery to charge. Once the base is plugged in, press the round button on the shaft of the stand so it illuminates like below, then press and hold the small button on the top of the screen until the screen turns on.
Turned Off Turned On
